Basically wear test is divide into two type of testing methods which is ring-on disc and pin-on disc. She received her M. So, the MMCs of aluminium alloy reinforced bottom ash are better than aluminium alloy reinforced fly ash. The result reveals that an increase in the percentage of reinforcement both bottom ash and fly ash in metal matrix composite decreases the material density. The reasonable processing parameters are:
Mechanical properties of incineration bottom ash: the influence of composite species.
After that green body is resulted then is being sintered until C. Among the evaluated components, Fe 2 O 3 and Al 2 O 3 are key factors; an increase in either results in higher strength at both dry and saturated conditions. The addition of the bottom ash and fly ash respectively to the aluminium alloy as reinforcement increase the density of the composites.
In this research, delamination is observed to be more extensive under the sliding distances of Graph of Density versus weight percentages of reinforcement Figure 4. After that green body is resulted then is being sintered until C. The hazardous metal content in the waste bottom ash was minimal, and the waste bottom ash was not contaminated by sea water. The wear rate has increased with increasing of weight percentage of fly ash and bottom composte bottom ash.